CONTACT

1.Add water to your dab rig’s chamber.
Test the waterline by inhaling with no banger in the downstem. If water backsplashes into your mouth, you have too much water in the rig. You need to pour some out.
Use your torch to heat the banger until it gets red because it’s so hot. You want to apply the torch to the outside and bottom because that’s where you’ll load the concentrate.
2.Wait 30-45 seconds for it to cool down once the banger is hot.
If it is too hot, it will scorch your concentrate, and that’s not how you do dabs.
3.Apply the wax onto the banger with your dabber, then slowly inhale it through the mouthpiece.
Rotate the dabber tip on the hot banger to avoid wasting any wax stuck on it. Use a long, slow inhale because most of the concentrate doesn’t vaporize instantly.
4.Cover the dab with a carb cap and finish inhaling.
The cap helps regulate the airflow and gives you a better hit. This is how to hit a dab rig. 
5.Exhale the vapor and repeat the process.
Remember to be cautious when you first begin dabbing. You don’t want to over-consume the concentrate and green out. It’s easy to do when dabs are so potent.
Read about the different types of wax dabs here.
Check out our blog on how to clean your glass here.

Unscrew the black lid.
Just pack a small amount of ground cannabis into the bowl, light it, inhale the complete hit, and then tap out the ash.
Make sure to pack the bowl fairly tightly so it doesn’t fall out, but not too tight as to completely restrict air flow through the pipe. Just like you would pack a bong, but much smaller.
Straight tube one hitters with the bowl on the end will need to be packed vertically.
And that’s it. Nothing more to it.

1. Gather your supplies. 
2. Grind down your flower with your fingers or your grinder, ensuring you are removing the stems. You don’t want to include the stems in your joint. Grind down as fine as you can, this will help create a smoother burn. 
3. Grab a filter/crutch/tip. Set it up by folding it up, accordion-style. This filter will help block the flower bits from getting into your mouth.
4. Place the filter/crutch/tip at one end of the rolling paper and fill in the rest of the rolling paper with ground flower. Make sure the flower is nestled next to the filter. 
5. Form and shape the ground flower into a joint shape. 
6. Next comes the actual rolling of the joint. Pinch the paper between your fingers and roll back and forth in order to pack the flower into the traditional cone shape. 
7. To seal the joint, lick the gum line of the rolling papers and seal with a final roll of the joint between your fingers. 
8. To finish, pack the open end of the joint with the tip of your finger. Then grab the loose paper and twist.
9. Light it up! You are good to go and ready to indulge in your joint!

Read the full blog here.

Kava is a plant well-known in the south pacific. This plant is made from the Piper methysticum plant and is known for its calming and relaxing properties. In the US, Kava has become known as the herb that gets users feeling drunk without touching any liquor!
Users can expect to feel euphoria, relaxation, better overall well-being, and a feeling of being content. Kava is the perfect natural herb to combine with Amanita as many of the effects overlap and work synergistically to offer users more potent results.

Legal and Trippy!
The twisted tales of amanita are as trippy as the mushroom itself. Amanita muscaria contains a high quantity of alkaloids and its pharmacology is complex and not fully understood.

Lion's Mane are mycelium-based products. Designated as the "Smart Mushroom", Lions Mane is ideal for anyone seeking cognition, memory, and mood support. And as a bonus, Lions Mane is well-known for supporting the nervous system.

Step 1: Gather Your Bong Cleaner and Start Prep
We recommend using 91-99% isopropyl alcohol for the best results. You’ll also want to grab a plastic bag, your bong, and a pair of gloves, if you’d like. Before you get started, remove your bong’s bowl (the part you put your flower in) and stem (the long piece the bowl is attached to). You can set these aside to make things easier later on. You may want to clean them separately if they look like they could use some TLC. Dump out any old water, too. 
Step 2: Do a Water Rinse
Start out by doing a simple rinse of your bong with some warm water. Add some to the inside of your bong and give it a few gentle shakes to distribute the water around. Empty the water.
Step 3: Add Some Salt and Alcohol
Place your bagged bong in the sink, then pour in your isopropyl alcohol to a point that’s about half of the usual amount of water you’d add in to smoke.
Next, add some coarse salt through the mouthpiece (the part you place your lips on to inhale) and into the bong.
Step 4: Get Shakin’
Carefully shake the salt and alcohol mixture in your bong to ensure it gets into all the nooks and crannies. You can repeat this process a few times if your piece is especially dirty.
Step 5: Let it Soak
This is really where your plastic bag can come in handy. After you’ve done some shaking, allow your bong to sit and soak for around 30 minutes or so.
Step 6: Empty, Rinse, and Repeat
Carefully remove it from the bag and empty the salt-alcohol mixture inside. Rinse the entire piece with warm water until all residue is gone.
Step 7: Dispose of Your Bong Bag
Once your bong has been sufficiently de-slimed, you can toss your plastic bag. Wipe down any surfaces that you’ve cleaned on, and voila – cleaning completed!

For a more in-depth answer, please check out our blog here.

Step 1: Load Your Flower
Remove the lid of the grinder. Using your fingers, break the bud into smaller pieces. Place the flower pieces around the center of the grinder, but not in the middle.
Step 2: Grind the Flower
Put the lid back on the grinder. Hold the bottom of the grinder with one had and rotate the lid with the other hand.
Step 3: Tap It
Before removing the lid, give your grinder a tap against the table or the palm of your hand to help dislodge the flower.
Step 4: Collect the Flower
Separate the grinding chamber from the collection chamber. Scoop out the newly ground flower.
Step 5: Enjoy
Use your freshly ground flower in a joint, pipe, or make your own edibles.

Step 1: Grind
Take a small amount of cannabis flower and break it up with your hands or a grinder.
Step 2: Pack
Pack the cannabis into the bowl of the pipe. The key is to not overpack the bowl. Packing the cannabis too tightly will restrict airflow, making it harder to smoke.
Step 3: Cover the Carb
Hold the pipe in the palm of your hand and place your finger or thumb over the carb, which depending on the type of pipe you're using, will either be on the side of the end of your pipe. If you're using a one-hitter, there's no carb to cover.
Step 4: Light It
Spark your lighter close to the surface of the bowl and inhale, keeping your finger on the carb. This will draw the flame to the bowl, ignite the flower, and create the smoke to inhale through the stem.
Step 5: Inhale
Once your flower starts to combust and cherry (the hot red part), lift the flame away from the bowl. You can keep the cherry burning by covering and uncovering the carb using a tapping motion while you inhale.
Step 6: Exhale and Repeat
Exhale and repeat until you've smoked all the cannabis in the bowl.
Check out our blog on how to clean your pipes here.

Step 1: Grind
Take a small amount of cannabis flower and break it up with your hands or a grinder.
Step 2: Pack
Pack the cannabis into the bowl of the pipe. The key is to not overpack the bowl. Packing the cannabis too tightly will restrict airflow, making it harder to smoke.
Step 3: Cover the Carb
Hold the pipe in the palm of your hand and place your finger or thumb over the carb, which depending on the type of pipe you're using, will either be on the side of the end of your pipe. If you're using a one-hitter, there's no carb to cover.
Step 4: Light It
Spark your lighter close to the surface of the bowl and inhale, keeping your finger on the carb. This will draw the flame to the bowl, ignite the flower, and create the smoke to inhale through the stem.
Step 5: Inhale
Once your flower starts to combust and cherry (the hot red part), lift the flame away from the bowl. You can keep the cherry burning by covering and uncovering the carb using a tapping motion while you inhale.
Step 6: Exhale and Repeat
Exhale and repeat until you've smoked all the cannabis in the bowl.
Check out our blog on how to clean your pipes here.

The word “shrooms” is generally used as an umbrella term for different types of psychedelic or “magic” mushrooms. 
Unlike the mushrooms we might eat in a dish, shrooms often contain compounds that can produce psychedelic effects, like hallucinations, distorted senses, and altered states of consciousness, also known as “trips.” The most common psychoactive compound found in these sorts of shrooms is psilocybin, but not all shrooms capable of impacting the brain rely on psilocybin to do so.
Many people turn to shrooms for recreational or medicinal purposes (or both), which isn’t a new phenomenon; many types of mushrooms have been used for centuries or even longer to treat common ailments, promote spiritual exploration, and bring people closer together. 
‍
In fact, some shrooms, like fly agaric (Amanita muscaria), are so ancient that researchers have traced their origins back to the period before indigenous peoples crossed from Eurasia to the Americas via the Bering Straits. That means that shroom use has been around for almost as long as modern human society has!

Shrooms that contain psilocybin are considered federally illegal, at least in the U.S., because psilocybin itself is a Schedule I Controlled Substance. This means that, in the eyes of the federal government, psilocybin has a high potential for misuse, no accepted medical uses, and can only be safely used under the supervision of a medical professional. 
Whether or not this classification of shrooms is really fair is up to you, but there are fortunately other options for those looking to experiment without breaking the law. Remember our friend _Amanita muscaria, _the classic red-and-white toadstool mushroom? Its active ingredients are not controlled substances, which means they are not subject to the same restrictions and legal penalties. 

Magic mushrooms, including those with psilocybin and things like _A. muscaria, _typically begin to kick in within about 30-60 minutes. Effects generally peak after an hour or two, and the entire trip will likely last from four to six hours. 
There are, of course, personal and biological factors that can affect how long your shroom experience lasts. The potency of the shrooms in question, the dose you take, and your own metabolism can all influence how strong a trip is and how long it sticks around.
Once your trip has come to a close, you can likely expect the remnants of your fungal friends to linger in your body for about one to three days. Keep in mind, though, that most standard drug tests don’t check for magic mushrooms, and if they do, they’re almost certainly looking for psilocybin. 
If drug testing is a concern of yours, it might be best to choose shrooms that are psilocybin-free or time your trips to leave enough days for your body to purge it from your system.

1. Use the right amount for your body.
2. Pay attention to side effects.
3. Talk to a doctor before starting any new medication plan, shroomy or not.
4. Take time to find the right products for your needs and goals.

Amanita Muscaria is a psychoactive, trippy, and federally legal mushroom. The twisted tales of Amanita are as trippy as the mushroom itself. Amanita muscaria contains a high quantity of alkaloids and its pharmacology is complex and not fully understood. The most relevant alkaloids are ibotenic acid, muscinol, muscarine, and muscazone.